MAC MCS2000 Instrucciones de operaciones descargar pdf (Pagina 9)

MCS2000 by MacAllister

Getting started...

Before you start

Lubrication

WARNING! The product is not lled with oil. It is essential

to ll the product with oil before using it! Never operate the

product without chain oil or with an empty oil tank, as this

will result in extensive damage to the product!

Never operate the bar and chain without lubrication oil!

Operating the product dry or with too little oil will decrease

cutting efciency, shorten the product life span and

cause rapid wear to the chain and bar from overheating!

Insufcient oil is evident by smoke or bar discoloration!

Adequate lubrication of the saw chain during cutting

operations is essential to minimise friction with the guide

bar. Your product is equipped with an automatic oiling

system! The oiling system automatically delivers the

proper amount of oil to the bar and chain!

Set the product on any suitable surface with the tank cap (13) >

facing upwards.

Unscrew and remove the tank >

cap (13), then add the lubricant

into the tank. Use a proper

funnel with a lter to prevent

debris entering the tank and to

avoid spilling and overlling the

tank. Do not overll and leave

approximately 5 mm of space

to the lower edge to allow the

lubricant to expand (Fig. 12).

5 mm

Fig. 12

NOTE: In summer use SAE #30; in winter, or if the trees

have excessive sap, use SAE #10.

MNL_MCS2000_DFT_GB_V06_111108.indd 9 11/8/11 5:11:10 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 46 47

Sin comentarios

MAC MCS2000 Instrucciones de operaciones Pagina 9